Re: Estimate and Drawing for Driveway Gate with Side Panel (fwd)

[Noelle <noelle>]

 > From: Adam Jacobsen <http://www.brianswelding.com/~adam>
 > Date: Mon, 26 Apr 2021 06:21:32 -0700
 > 
 > Hi There, In response to these questions: 
 > 
 > 3:The kickplate is not necessary and our quote was written incorrectly. It 
 > was supposed to have a note saying that the kick plate costs an extra 750$
 > 
 > The kick plate is just a decorative thing.
 > 
 > 4:We will not pull any permits for this job. A gate project does not require 
 > a permit in where-I-live. If the gate was going to have a motor put on it then 
 > the electrical work for that could require a permit. 
 > 
 > Thanks, Adam
 > 
 > > On Apr 25, 2021, at 8:16 AM, Noelle <http://dummy.us.eu.org/noelleg> 
 > > wrote:
 > > 
 > > Thanks for your answers.
 > > 
 > > A few more questions:
 > > 
 > >  3. Is kick plate needed?  If not, would excluding it change the 
 > >  manufacturing cost?
 > >  4. Will you be pulling building permits for this work?
 > > 
 > > Thanks.
 > > 
 > >  > From: Adam Jacobsen <http://www.brianswelding.com/~adam>
 > >  > Date: Fri, 23 Apr 2021 11:54:30 -0700
 > >  >
 > >  > Hi there,
 > >  >
 > >  >  In response to those questions, We can decide that hinge direction 
 > >  >  later.
 > >  >  Both directions can work.
 > >  >
 > >  > The gravity latch is normally on the inside and it has a hole for a 
 > >  > padlock.
 > >  > If needed we can add tabs with holes so a lock can be put on the front.
 > >  >
 > >  > Let me know if you have any other questions.
 > > 
 > > On Friday, April 23, 2021, 8:36:30 AM PDT, Noelle <http://dummy.us.eu.org/noelleg> wrote:
 > > 
 > > Adam - a couple of questions:
 > > 
 > >  1. I cannot tell just from the drawing whether the gate swings one way or
 > >      the other.  Does it matter?  Can that be decided later?
 > >  2. Would the gravity latch appear on the outside so that a lock can be
 > >      added?
 > > 
 > > Thanks.