Re: Estimate and Drawing for Driveway Gate with Side Panel (fwd)

[Noelle <noelle>]

 > From: Adam Jacobsen <http://www.brianswelding.com/~adam>
 > Date: Mon, 26 Apr 2021 17:13:16 -0700
 > Cc: Noelle <http://dummy.us.eu.org/noelleg>
 > To: Noelle <http://dummy.us.eu.org/noelleg>
 > 
 > Hi Noelle,
 > 
 > I’ll have our office resend the quote tomorrow morning with the kick plate 
 > part left out.
 > 
 > I’ll be available later this week to come out and get the exact 
 > measurements.
 > 
 > Thanks, Adam
 > 
 > > On Apr 26, 2021, at 12:19 PM, Noelle <http://dummy.us.eu.org/noelleg> 
 > > wrote:
 > > 
 > > Thanks for your answers.
 > > 
 > > I would like to exclude the kick plate, then.  If I want to move ahead 
 > > without the kick plate, should I wait until the quote/estimate is updated 
 > > before signing and sending back the work order?
 > > 
 > > Thanks.
 > > 
 > >  > Hi There, In response to these questions:
 > >  >
 > >  > 3:The kickplate is not necessary and our quote was written incorrectly. 
 > >  > It
 > >  > was supposed to have a note saying that the kick plate costs an extra 
 > >  > 750$
 > >  >
 > >  > The kick plate is just a decorative thing.
 > >  >
 > >  > 4:We will not pull any permits for this job. A gate project does not 
 > >  > require
 > >  > a permit in where-I-live. If the gate was going to have a motor put on it 
 > >  > then
 > >  > the electrical work for that could require a permit.
 > >  >
 > >  > Thanks, Adam